DES-3000 Series Layer 2 Switch CLI Reference Manual
118
Example usage:
To map a static MAC address to hardware queue 3:
DES-3026:4#config cos mac_mapping destination_addr 01-00-D6-
E4-FF-05 class 3
Command: config cos mac_mapping destination_addr 01-00-D6-E4-
FF-05 class 3
Success.
DES-3026:4#
show cos mac_mapping
Purpose Used to display MAC address CoS mapping configuration.
Syntax
show cos mac_mapping { destination_addr < macaddr > }
Description Use this command to view a single entry or all entries configured for CoS
MAC address mapping.
Parameters destination_addr < macaddr > – Specify a static MAC address entry to view
the current CoS mapping configuration. If no entry specified, all MAC
mapping entries are listed.
Restrictions None.
Example usage:
To view the current CoS mapping for static MAC addresses:
DES-3026:4#show cos mac_mapping
Command: show cos mac_mapping
MAC Address Class
-----------------------------------
01-00-D6-E4-FF-05 3
DES-3026:4#
config cos tos value
Purpose Used to map the Type of Service (ToS) value in the IP header of incoming
packets to one of the four hardware queues available on the switch.
Syntax
config cos tos value <value 0-7> [class <class_id 0-3>]
Description Use this command to map ToS priority value in the IP header of an incoming
packet to one of the hardware queues on the Switch.
Parameters <value 0-7> – Specifies the ToS value in the IP header to be mapped.
class <class_id 0-3> – Specify the hardware queue to which the ToS value is
mapped.
Restrictions Only Administrator-level users can issue this command.
To Next Page
Loading...
