DES-3000 Series Layer 2 Switch CLI Reference Manual
119
Example usage:
To map a ToS priority value 3 to a hardware queue 2 for incoming packets with ToS information:
DES-3026:4#config cos tos value 3 class 2
Command: config cos tos value 3 class 2
Success
DES-3026:4#
show cos tos
Purpose Used to display the current ToS mapping configuration on the Switch.
Syntax
show cos tos {value <value 0-7>}
Description Use this command to view ToS mapping for any or all ToS priority values.
Parameters value <value 0-7> – Specifies a ToS value in order to view CoS mapping
configuration for that value. If no value is specified, all eight ToS mapped
values are listed.
Restrictions None.
Example usage:
To show the CoS to ToS mapping.
DES-3026:4#show cos tos
Command: show cos tos
TOS value Class
---------------------------
0 0
1 0
2 0
3 2
4 0
5 0
6 0
7 0
DES-3026::4#
To Next Page