DES-3000 Series Layer 2 Switch CLI Reference Manual
142
show address_binding
the IP-MAC blocked binding is made. This entry is to be made with
the vlan name listed above to view this blocked entry.
ports – Enter this parameter to view the ports which are enabled for IP-
MAC binding.
Restrictions None.
Example usage:
To show IP-MAC binding entries on the switch:
DES-3026:4#show address_binding ip_mac ipaddress
10.1.1.8 mac_address 00-00-00-00-00-12
Command: show address_binding ip_mac ipaddress
10.1.1.8 mac_address 00-00-00-00-00-12
Enabled ports: 2
IP Address MAC Address
--------------- -----------------
10.1.1.8 00-00-00-00-00-12
Total entries : 1
DES-3026:4#
delete address_binding
Purpose Used to delete an IP-MAC address binding entry.
Syntax
delete address_binding
[ip_mac [ipaddress <ipaddr> mac_address <macaddr>
| all] | blocked [all | vlan_name <vlan_name> mac_address <macaddr>]]
Description This command will delete IP-MAC address binding entries. Two methods of deletion
can be applied.
IP_MAC – Individual Address Binding entries can be deleted by entering the
physical and IP addresses of the device. Toggling to all will delete all the Address
Binding entries.
Blocked – Blocked address binding entries (bindings between VLAN names and
MAC addresses) can be deleted by entering the VLAN name and the physical
address of the device. To delete all the blocked IP-MAC address binding entries,
toggle all.
Parameters ip_mac – Select this parameter to delete a specific IP-MAC address binding entry by
entering the following IP-MAC address binding information.
ipaddress <ipaddr> – Enter the IP address of the device where the IP-MAC
address binding is made. This entry will be used in conjunction with the
following MAC address to identify the binding entry to be deleted.
<macaddr> – The MAC address of the device where the IP-MAC address
binding entry is made. This entry will be used in conjunction with the previous
IP address to identify the binding entry to be deleted.
all – Entering this parameter will delete all IP-MAC address binding entries.
blocked – Entering this parameter will specify that the user wishes to delete a
particular blocked IP-MAC address entry, defined by entering the following
To Next Page
Loading...
