DES-3000 Series Layer 2 Switch CLI Reference Manual
143
delete address_binding
parameters.
all – Entering this parameter will delete all blocked IP-MAC address binding
entries.
vlan_name <vlan_name> – Enter the VLAN name of the VLAN that is bound to
a MAC address which the user wishes to delete. This entry must be
implemented with the following parameter to specify the entry to be deleted.
<macaddr> – The MAC address of the device where the blocked IP-MAC
address binding is made. This entry will be used in conjunction with the
previous VLAN Name to identify the binding entry to be deleted.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete an IP-MAC Binding on the switch:
DES-3026:4#delete address-binding ip-mac ipaddress
10.1.1.1 mac_address 00-00-00-00-00-06
Command: delete address-binding ip-mac ipaddress
10.1.1.1 mac_address 00-00-00-00-00-06
Success.
DES-3026:4#
enable address_binding trap_log
Purpose Used to enable the trap log for the IP-MAC binding function.
Syntax
enable address_binding trap_log
Description
This command, along with the disable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn’t match the IP-MAC binding configuration set on the
Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable sending of IP-MAC Binding trap log messages on the Switch:
DES-3026:4#enable address_binding
trap_log
Command: enable address_binding
trap_log
Success.
DES-3026:4#
To Next Page
Loading...
