DES-3000 Series Layer 2 Switch CLI Reference Manual
144
disable address_binding trap_log
Purpose Used to disable the trap log for the IP-MAC binding function.
Syntax
disable address_binding trap_log
Description
This command, along with the enable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn’t match the IP-MAC binding configuration set on the
Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable sending of IP-MAC Binding trap log messages on the Switch:
DES-3026:4#disable address_binding
trap_log
Command: disable address_binding
trap_log
Success.
DES-3026:4#
config address_binding aging_interval
Purpose Used to configure the interval time for auto recovery of a blocked IP-
MAC entry.
Syntax
config address_binding aging_interval [infinite | <sec 1-65535>]
Description This command, is used when the device does not support Auto
Recovery.
Parameters <sec 1-65535> – Enter an aging time in seconds between 1 and
65535.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the interval time for auto recovery of a blocked IP-MAC entry:
DES-3026:4#config address_binding
aging_interval infinite
Command: config address_binding
aging_interval infinite
Success.
DES-3026:4#
To Next Page
Loading...
