D-Link DES-3010F - Page 189

DES-3000 Series Layer 2 Switch CLI Reference Manual
185
show radius auth_client
Purpose Used to display the current RADIUS authentication client.
Syntax
show auth_client
Description
The show auth_client command is used to display the current
RADIUS authentication client currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To view the current RADIUS authentication client:
DES-3026:4#show auth_client
Command: show auth_client
radiusAuthClient ==>
radiusAuthClientInvalidServerAddresses 0
radiusAuthClientIdentifier D-Link
radiusAuthServerEntry ==>
radiusAuthServerIndex : 1
radiusAuthServerAddress : 0.0.0.0
radiusAuthClientServerPortNumber 0
radiusAuthClientRoundTripTime 0
radiusAuthClientAccessRequests 0
radiusAuthClientAccessRetransmissions 0
radiusAuthClientAccessAccepts 0
radiusAuthClientAccessRejects 0
radiusAuthClientAccessChallenges 0
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators 0
radiusAuthClientPendingRequests 0
radiusAuthClientTimeouts 0
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_diagnostics
Purpose Used to display the current authentication diagnostics.
Syntax
show auth_diagnostics {ports <portlist>}
Description
The show auth_diagnostics command is used to display the
current authentication diagnostics of the Switch on a per port basis.