DES-3000 Series Layer 2 Switch CLI Reference Manual
186
show auth_diagnostics
Parameters
ports <portlist> Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the current authentication diagnostics for port 16:
DES-3026:4#show auth_diagnostics ports 1
Command: show auth_diagnostics ports 1
Port number : 1
EntersConnecting 0
EapLogoffsWhileConnecting 0
EntersAuthenticating 0
SuccessWhileAuthenticating 0
TimeoutsWhileAuthenticating 0
FailWhileAuthenticating 0
ReauthsWhileAuthenticating 0
EapStartsWhileAuthenticating 0
EapLogoffWhileAuthenticating 0
ReauthsWhileAuthenticated 0
EapStartsWhileAuthenticated 0
EapLogoffWhileAuthenticated 0
BackendResponses 0
BackendAccessChallenges 0
BackendOtherRequestsToSupplicant 0
BackendNonNakResponsesFromSupplicant 0
BackendAuthSuccesses 0
BackendAuthFails 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_session_statistics
Purpose Used to display the current authentication session statistics.
Syntax
show
auth_session_statistics {ports <portlist>}
Description
The show auth_session statistics command is used to display
the current authentication session statistics of the Switch on a
per port basis.
Parameters
ports <portlist> Specifies a port or range of ports to be viewed.
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To Next Page