DES-3000 Series Layer 2 Switch CLI Reference Manual
46
DES-3026:4#
show snmp traps
Purpose Used to show SNMP trap support on the Switch .
Syntax
show snmp traps
Description This command is used to view the SNMP trap support status
currently configured on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To view the current SNMP trap support:
DES-3026:4#show snmp traps
Command: show snmp traps
SNMP Trap : Enabled
Authenticate Traps : Enabled
DES-3026:4#
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for
the Switch.
Syntax
config snmp system_contact {<sw_contact>}
Description
The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 characters can be
used.
Parameters <sw_contact> – A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
MIS Department II
”:
DES-3026:4#config snmp system_contact MIS
Department II
Command: config snmp system_contact MIS Department
II
Success.
DES-3026:4#
To Next Page
Loading...
