D-Link DES-3010F - Page 51

DES-3000 Series Layer 2 Switch CLI Reference Manual
47
config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax
config snmp system_location {<sw_location>}
Description
The config snmp system_location command is used to enter a
description of the location of the Switch. A maximum of 255
characters can be used.
Parameters <sw_location> – A maximum of 255 characters is allowed. A NULL
string is accepted if there is no location desired.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Switch location for “
HQ 5F ”:
DES-3026:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DES-3026:4#
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax
config snmp system_name {<sw_name>}
Description
The config snmp system_name command configures the name of
the Switch.
Parameters <sw_name> – A maximum of 255 characters is allowed. A NULL
string is accepted if no name is desired.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Switch name for “
DES-3026 Switch” :
DES-3026:4#config snmp system_name DES-3026 Switch
Command: config snmp system_name DES-3026 Switch
Success.
DES-3026:4#