D-Link DES-3010G - Page 60

DES-3000 Series Layer 2 Switch CLI Reference Manual
56
config dhcp_relay option82
command.
Example usage:
To configure dhcp_relay option 82:
DES-3026:4# config dhcp_relay option_82 state enable
Command: config dhcp_relay option_82 state enable
Success.
DES-XXXXS:4#config dhcp_relay option_82 check disable
Command: config dhcp_relay option_82 check disable
Success.
DES-XXXXS:4#config dhcp_relay option_82 policy replace
Command: config dhcp_relay option_82 policy replace
Success.
DES-3026:4#
enable dhcp_relay
Purpose Used to enable the DHCP relay function on the switch.
Syntax
enable dhcp_relay
Description
The enable dhcp_relay command enables the DHCP relay function
on the switch.
Parameters None
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To enable the DHCP relay function:
DES-3026:4#enable dhcp_relay
Command: enable dhcp_relay
Success.
DES-3026:4#