D-Link DGS-1100-18 - Ipv6 Interface; Port Configuration; Port Settings

D-Link DGS-1100 Series Switch User Manual
Mask
If Static is selected, enter the IP address of the switch. If
DHCP or BOOTP is selected, the automatically obtained
network mask will be displayed.
Gateway
If Static is selected, enter the IP address of the switch. If
DHCP or BOOTP is selected, the automatically obtained
gateway will be displayed.
DHCP retry Time
If DHCP is selected, enter the number of times to retry
obtaining an IP address.
Click the Apply button to accept the changes made.
IPv6 Interface
This window is used to configure the IPv6 settings of the switch.
To view the following window, click System > System Information Settings > IPv6 Interface, as
shown below:
Figure 5-4 Peripheral Settings window
The fields that can be configured are described below:
Parameter Description
IPv6 State Select whether to Enable or Disable IPv6 functionality.
Static IPv6 Address
If enabled, enter the static IPv6 address of the switch.
Click the Apply button to accept the changes made.
Port Configuration
Port Settings
This window is used to view and configure the Switch’s port settings.
To view the following window, click System > Port Configuration > Port Settings, as shown below:
Figure 5-5 Port Settings window
2
2
0
0