Need help?Do you have a question about the D-Link DGS-1210-52MP and is the answer not in the manual?
General| PoE Standard | IEEE 802.3af/at |
|---|---|
| PoE Budget | 370W |
| Switching Capacity | 104 Gbps |
| Forwarding Rate | 77.4 Mpps |
| MAC Address Table Size | 16K |
| Power Input | 100-240 VAC, 50/60 Hz |
| Ports | 48 x 10/100/1000BASE-T PoE+, 4 x Gigabit SFP |
| Jumbo Frame Support | 9216 Bytes |
| Dimensions | 440 x 250 x 44 mm |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -40 to 70 °C (-40 to 158°F) |
| Humidity | 5% to 95% non-condensing |
Lists precautions to reduce the risk of injury, shock, fire, and equipment damage during installation.
Explains how to configure the switch, monitor status, and display statistics using a web browser.
Details the equipment needed and steps to connect the switch for web configuration.
Explains how to log in to the switch's web interface using an Ethernet connection.
Utility for initial configuration of switch mode, IP, password, and SNMP.
Steps to establish a TELNET connection to the switch.
Instructions for logging into the CLI using username and password.
Lists basic switch commands available in the Command Line Interface.
Details the device specifications including switching capacity, forwarding rate, and packet buffer.
Lists Layer 2 features like MAC address table, Jumbo frames, IGMP snooping, STP, LACP, etc.
Lists Layer 3 features like ARP, VLAN, routing, etc.
General safety guidelines for personal safety and product protection.
To Next Page
