Need help?Do you have a question about the D-Link DGS-1210-28 and is the answer not in the manual?
General| Switching Capacity | 56 Gbps |
|---|---|
| Forwarding Rate | 41.7 Mpps |
| RAM | 128 MB |
| Humidity | 10% to 90% non-condensing |
| Ports | 24 x 10/100/1000BASE-T |
| MAC Address Table | 16K |
| VLANs | 4K VLANs |
| QoS | 802.1p Quality of Service |
| Management | Web-based GUI, SNMP |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Jumbo Frame | 9216 bytes |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Standards Compliance | IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x, 802.1D, 802.1w, 802.1s, 802.1Q, 802.1p |
Provides safety recommendations for switch installation.
Instructions for securely connecting the AC power cord.
Explains how to use the web browser interface for management.
Guides on accessing the web interface with IP and credentials.
Configures IP address, Netmask, and Gateway settings.
Overview of the Web-based Management interface layout.
Describes saving and restoring switch configurations via HTTP or TFTP.
Configure IP address and basic system information.
Configure IPv6 system information.
Set and manage the switch's password.
Monitor and adjust port status and speed.
Configure 802.1Q VLAN settings.
Configure global settings for Voice VLAN.
Configure Voice VLAN settings on a per-port basis.
Configure Auto Surveillance VLAN for video traffic.
Configure global Spanning Tree Protocol (STP) settings.
Configure port trunking for increased bandwidth.
Configure IGMP snooping for efficient multicast traffic.
Configure MLD snooping for IPv6 multicast traffic.
Configure global LLDP settings for network discovery.
Define bandwidth settings for ports.
Configure Quality of Service priority levels.
Manage trusted host IP addresses for switch access.
To Next Page