D-Link DGS-1210-28 - Config Account Admin Password; Save

5 Command Line Interface D-Link Web Smart Switch User Manual
9
9
1
1
DGS-1210-28> show switch
System Name :
System Contact :
System Location :
System up time : 0 days, 6 hrs, 32 min, 17 secs
System Time : 02/01/2012 06:32:19
System hardware version : C1
System firmware version : 4.00.011
System boot version : 1.00.005
System Protocol version : 2.001.004
System serial number : QBDGS12102800
MAC Address : 00-66-60-60-88-28
DGS-1210-28>
config account admin password
Purpose To display the configuration of an IP interface on the Switch.
Syntax
config account admin password <pas s wd>
Description
The config account admin password command
sets the
administrator password.
Parameters
<passwd> − The new password of the administrator.
Restrictions None.
Example usage:
To configure the account admin password:
DGS-1210-28> config account admin password 1234
DGS-1210-28>
save
Purpose To save changes in the Switch’s configuration to non-volatile
RAM.
Syntax
save
Description
The save command saves the configuration changes to the
memory.
Parameters None.
Restrictions None.
Example usage:
To save the Switch’s current configuration to non-volatile RAM: