D-Link DGS-1210-10P User Manual

D-Link DGS-1210-10P Specifications

General

Number of queues	4
MAC address table	8000 entries
Store-and-forward	Yes
Packet buffer memory	0.5 MB
Maximum data transfer rate	1 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
10G support	No
Networking standards	IEEE 802.2, IEEE 802.3, IEEE 802.3u, IEEE 802.3x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Networking features	Gigabit Ethernet
Packet transfer speed	14.88
Connectivity technology	Wired
Ethernet interface type	Fast Ethernet, Gigabit Ethernet
DHCP features	DHCP server, DHCP client
Security algorithms	802.1x RADIUS
Switch type	-
Switch layer	L2
Fiber optic connector	SFP
SFP/SFP+ slots quantity	2
Basic switching RJ-45 Ethernet ports quantity	10
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	109.6 W
Safety	cUL, LVD
Certification	FCC, CE, IC, VCCI, C-Tick
Product color	Black
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 95 %

Weight and Dimensions

Depth	180 mm
Width	330 mm
Height	44 mm
Weight	1840 g

Summary

Hardware Installation

Unpacking and Switch Installation

Covers unpacking, desktop/shelf, and rack mounting procedures for the switch.

Power Connection and Power Failure Handling

Getting Started with Management

Web-based Management and SmartConsole Setup

SmartConsole Utility Guide

SmartConsole Interface Overview

SmartConsole Settings and Tools

SmartConsole Device Configuration

Device Settings and Management Tools

Details how to set IP address, system name, and other device parameters.

Password Management and Firmware Upgrade

Basic Switch Configuration

Smart Wizard and Initial Settings

System Network Configuration

Web-based Management Interface

Interface Navigation and Session Management

Configuration Management Tools

Tools for saving configurations, restoring settings, and resetting the switch.

Advanced Configuration Utilities

System and Network Settings

System Settings and Network Parameters

Network Segmentation and Traffic Management

Port Settings, SNMP, and System Logs

Jumbo Frames and 802.1Q VLANs

Enabling jumbo frames and configuring 802.1Q VLANs for network segmentation.

Advanced VLAN, Link Aggregation, and IGMP

VLAN Configuration and Voice VLAN

Configuring VLANs, including Asymmetric, Management, and Voice VLANs.

Link Aggregation and Port Trunking

IGMP Snooping and Port Mirroring

System Optimization and Time Management

Power Saving and Loopback Detection

Spanning Tree Protocol (STP) Configuration

Setting up STP and RSTP for network loop prevention and topology management.

Network Traffic Control and Security

QoS and Bandwidth Management

Configuring QoS for traffic prioritization and controlling bandwidth.

Comprehensive Network Security Features

Covers Trusted Host, Safeguard Engine, Port Security, 802.1X, MAC Address Control, and ACLs.

Monitoring, Diagnostics, and PoE

Monitoring and Diagnostics Tools

PoE Management and System Settings

Configuring PoE functionality for ports and managing overall PoE power budget.

Command Line Interface (CLI) Operations

Connecting and Logging into CLI

Common CLI Commands and Usage

Overview of essential CLI commands for system management, configuration, and monitoring.