37
SNMP Community / Trap: To configure the SNMP Community or
SNMP Trap configuration.
Configure SNMP Community:
Figure 25. SNMP Community Setting
Add Group: To add a SNMP Community group, press “Add
Group” button, the Add SNMP Community configuration window
will pop out; fill in the community name and assign the community
enable read_only or read_write. Press “Apply” button to execute the
setting.
Figure 26. Add SNMP Community group
Delete Group: To delete previously defined SNMP Community
group, press “Delete Group” button, the Delete SNMP Community
To Next Page
Loading...
