DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch Hardware Installation Guide
20
Figure 2-16 Installing the DPS-900 into a rack
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.
To Next Page
Loading...
