D-Link DGS-3024 - SNMP Group Table

DGS-3024 Layer 2 Switch CLI Reference Manual
19
802.1X COMMANDS
The DGS-3024 implements the server-side of the IEEE 802.1x Port-based Network Access Control. This mechanism is intended
to allow only authorized users, or other network devices, access to network resources by establishing criteria for each port on
the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x auth_state {ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802.1x capability ports [<portlist> | all] [authenticator | none]
config 802.1x
auth_parameter ports
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> |
server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 1-65535> | enable_reauth [enable | disable]}]
config 802.1x auth_protocol [radius_eap | radius_pap]
config 802.1x init [port_based ports [<portlist> | all]
config 802.1x reauth [port_based ports [<portlist> | all]
config radius add <server_index 1-3> <server_ip> key <passwd 32> [default
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
config radius delete <server_index 1-3>
config radius <server_index 1-3> {ipaddress <server_ip> | key <passwd 32>
[auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
show radius
create 802.1x user <username 15>
delete 802.1x user <username 15>
show 802.1x user
Each command is listed, in detail, in the following sections.
enable 802.1x
Purpose Used to enable the 802.1x server on the Switch.
Syntax
enable 802.1x
Description
The enable 802.1x command enables the 802.1x Port-based Network
Access control server application on the Switch.
Parameters None.
108