D-Link DGS-3024 - VLANs

DGS-3024 Layer 2 Switch CLI Reference Manual
7
MAC NOTIFICATION COMMANDS
The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command Parameters
enable mac_notification
disable mac_notification
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>}
config mac_notification ports [<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports <portlist>
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose Used to enable global MAC address table notification on the
Switch.
Syntax
enable mac_notification
Description This command is used to enable MAC Address Notification without
changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable MAC notification without changing basic configuration:
DGS-3024:4#enable mac_notification
Command: enable mac_notification
Success.
DGS-3024:4#
disable mac_notification
Purpose Used to disable global MAC address table notification on the Switch.
Syntax
disable mac_notification
Description This command is used to disable MAC Address Notification without
changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
47