DGS-3024 Layer 2 Switch CLI Reference Manual
23
COMMAND HISTORY LIST
The command history list commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
?
show command_history
dir
config command_history <value 1-40>
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax
? {<command>}
Description This command will display all of the commands available through the
Command Line Interface (CLI).
Parameters <command> - Entering the question mark with an appropriate command
will list all the corresponding parameters for the specified command, along
with a brief description of the commands function and similar commands
having the same words in the command.
Restrictions None.
Example usage
To display all of the commands in the CLI:
DGS-3024:4#?
?
clear counters
config 802.1p default_priority
config 802.1x auth_protocol
Command: ?
..
clear
clear arptable
clear fdb
clear log
config 802.1p user_priority
config 802.1x auth_parameter ports
config 802.1x capability ports
config 802.1x init
config 802.1x reauth
config account
config arp_aging time
config arpentry
config command history
config dst
config fdb_aging_time minutes
132
To Next Page
Loading...
