DGS-3024 Layer 2 Switch CLI Reference Manual
6
NETWORK MANAGEMENT (SNMP) COMMANDS
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
The DGS-3024 supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. The user may specify which
version of the SNMP to use to monitor and control the Switch. The three versions of SNMP vary in the level of security
provided between the management station and the network device. The following table lists the security features of the three
SNMP versions:
SNMP
Version
Authentication Method Description
v1 Community String
Community String is used for authentication − NoAuthNoPriv
v2c Community String
Community String is used for authentication − NoAuthNoPriv
v3 Username
Username is used for authentication − NoAuthNoPriv
v3 MD5 or SHA
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms
− AuthNoPriv
v3 MD5 DES or SHA DES
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms
− AuthPriv.
DES 32-bit encryption is added based on the CBC-DES (DES-32)
standard
Command Parameters
create snmp user <username 32> <groupname 32> {encrypted [by_password
auth [md5 <auth_password 8-16> | sha <auth_password 8-
20>] priv [none | des <priv_password 8-16>] | by_key auth
[md5 <auth_key 32-32>| sha<auth_key 40-40>] priv [none |
des <priv_key 32-32>]]}
delete snmp user <username 32>
show snmp user
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | oid]
show snmp view {<view_name 32>}
create snmp community <community_string 32> view <view_name 32> [read_only |
read_write]
delete snmp community <community_string 32>
show snmp community {<community_string 32>}
config snmp engineID <snmp_engineID>
show snmp engineID
create snmp group <groupname 32> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
25
To Next Page
Loading...
