D-Link DGS-3024 - Port Configuration

DGS-3024 Layer 2 Switch CLI Reference Manual
Success.
DGS-3024:4#
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>}
Description This command is used to display the current configuration of a range
of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the configuration of ports 1-5 on the Switch:
DGS-3024:4#show ports 1-5
Command: show ports 1-5
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
--- -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled Link Down Enabled
2 Enabled Auto/Enabled Link Down Enabled
3 Enabled Auto/Enabled Link Down Enabled
4 Enabled Auto/Enabled Link Down Enabled
5 Enabled Auto/Enabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
24