DGS-3024 Layer 2 Switch CLI Reference Manual
Example Usage:
To disable MAC notification without changing basic configuration:
DGS-3024:4#disable mac_notification
Command: disable mac_notification
Success.
DGS-3024:4#
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> |
historysize <int 1-500>
Description MAC address notification is used to monitor MAC addresses
learned and entered into the FDB.
Parameters interval <int 1-2147483647> - The time in seconds between
notifications. The user may choose an interval between 1 and
2,147,483,647 seconds.
historysize <1-500> - The maximum number of entries listed in the
history log used for notification.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch’s MAC address table notification global settings:
DGS-3024:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3024:4#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist> | all] [enable | disable]
Description MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters <portlist> - Specify a port or range of ports to be configured.
all – Entering this command will allow the configuration of all ports on
the system.
[enable | disable] – These commands will enable or disable MAC
To Next Page
Loading...
