DGS-3024 Layer 2 Switch CLI Reference Manual
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init [port_based ports [<portlist> | all]
Description
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters port_based ports – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can then be
specified.
<portlist> − Specifies a port or range of ports to be initialized.
all − Specifies all of the ports on the Switch to be initialized.
Restrictions Only administrator-level users can issue this command.
Example usage:
To initialize the authentication state machine of some or all:
DGS-3024:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3024:4#
config 802.1x reauth
Purpose Used to configure the 802.1x re-authentication feature of the Switch.
Syntax
config 802.1x reauth [port_based ports [<portlist> | all]
Description
The config 802.1x reauth command is used to re-authenticate a previously
authenticated device based on a port number.
Parameters port_based – This instructs the Switch to re-authorize 802.1x function
based only on the port number. Ports approved for re-authorization can
then be specified.
ports <portlist> − Specifies a port or range of ports to be
reauthorized.
all − Specifies all of the ports on the Switch to be reauthorized.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
114
To Next Page
Loading...
