D-Link DGS-3024 - Page 118

DGS-3024 Layer 2 Switch CLI Reference Manual
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description
The config radius delete command is used to delete a previously entered
RADIUS server configuration.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to three groups of RADIUS server settings can be
entered on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DGS-3024:4#config radius delete 1
Command: config radius delete 1
Success.
DGS-3024:4#
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> {ipaddress
<server_ip> | key <passwd 32> | auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}
Description
The config radius command is used to configure the Switch’s RADIUS
settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
 <passwd 32> − The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
default − Returns all of the ports in the range to their default RADIUS
settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example usage:
116