DGS-3024 Layer 2 Switch CLI Reference Manual
Example usage:
To delete the default IP route 10.53.13.254:
DGS-3024:4#delete iproute default 10.53.13.254
Command: delete iproute default 10.53.13.254
Success.
DGS-3024:4#
show iproute
Purpose Used to display the Switch’s current IP routing table.
Syntax
show iproute {<network address>} {static}
Description This command will display the Switch’s current IP routing table.
Parameters network address – IP address and netmask of the IP interface that is
the destination of the route. The address and mask information may
be specified by using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
static - Use this parameter to display static iproute entries.
Restrictions None.
Example Usage:
To display the contents of the IP routing table:
DGS-3024:4#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Hops Protocol
--------------- --------------- --------------- ---- -----------
0.0.0.0 10.1.1.254 System 1 Default
10.0.0.0/8 10.48.74.122 System 1 Local
Total Entries: 2
DGS-3024:4#
127
To Next Page
Loading...
