DGS-3024 Layer 2 Switch CLI Reference Manual
config arpentry
Parameters
<ipaddr> − The IP address of the end node or station.
Only administrator-level users can issue this command.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions
Example Usage:
To configure a static ARP entry for the IP address 10.48.74.12 and MAC address 00:50:BA:00:07:36:
DGS-3024:4#config arpentry 10.48.74.12 00-50-BA-00-07-36
Command: config arpentry 10.48.74.12 00-50-BA-00-07-36
Success.
DGS-3024:4#
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {<ipaddr> | all}
Description This command is used to delete a static ARP entry, made using
the create arpentry command above, by specifying either the IP
address of the entry or all. Specifying all clears the Switch’s ARP
table.
Parameters
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DGS-3024:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DGS-3024:4#
config arp_aging time
Purpose Used to configure the age-out timer for ARP table entries on the
Switch.
Syntax
config arp_aging time <value 0-65535 >
129
To Next Page
Loading...
