DGS-3024 Layer 2 Switch CLI Reference Manual
DGS-3024:4#config traffic control ports all state enable
Command: config traffic control ports all state enable
Success.
DGS-3024:4#config traffic control storm_type broadcast threshold 15000
Command: config traffic control storm_type broadcast threshold 15000
Success.
DGS-3024:4#config traffic control threshold 15000
Command: config traffic control threshold 15000
Success.
DGS-3024:4#
show traffic control
Purpose Used to display current traffic control settings.
Syntax
show
traffic control {ports <portlist>}
Description This command displays the current storm traffic control configuration
on the Switch.
Parameters ports <portlist> - Enter a port or range of ports to be viewed.
Restrictions None.
Example usage:
To display traffic control setting for ports 1-5:
DGS-3024:4#show traffic control
Command: show traffic control
Traffic Control
Storm Control Type: broadcast
Threshold : 15000
Port State
---------- ------------
1 Enabled
2 Enabled
3 Enabled
4 Enabled
5 Enabled
Total Entries: 5
DGS-3024:4#
79
To Next Page
Loading...
