DGS-3024 Layer 2 Switch CLI Reference Manual
config scheduling
to transmit before allowing the next lowest priority classes of service
to transmit its packets. A value between 0 and 15 packets can be
specified. The default value is 0.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure traffic scheduling:
DGS-3024:4# config scheduling 3 max_packet 15
Command: config scheduling 3 max_packet 15
Success.
DGS-3024:4#
show scheduling
Purpose Used to display the currently configured traffic scheduling on the
Switch.
Syntax
show scheduling
Description
The show scheduling command displays the current configuration
for the maximum number of packets (max_packet) value assigned
to the four priority classes of service on the Switch. The Switch will
empty the four hardware classes of service in order, from the highest
priority (class 3) to the lowest priority (class 0).
Parameters None.
Restrictions None.
Example usage:
To display the current scheduling configuration:
DGS-3024:4# show scheduling
Command: show scheduling
QOS Output Scheduling
MAX. Packets
-------------------
Class-0 0
Class-1 1
Class-2 5
Class-3 15
DGS-3024:4#
82
To Next Page
Loading...
