DGS-3024 Layer 2 Switch CLI Reference Manual
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest]
Description This command configures to part of the packet examined by the Switch when
selecting the egress port for transmitting load-sharing data. This feature is only
available using the address-based load-sharing algorithm.
Parameters
mac_source − Indicates that the Switch should examine the MAC source
address.
mac_destination − Indicates that the Switch should examine the MAC destination
address.
mac_source_dest − Indicates that the Switch should examine the MAC source
and destination addresses
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3024:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3024:4#
show link_aggregation
Purpose Used to display the current link aggregation configuration on the Switch.
Syntax
show link_aggregation {group_id <value 1-4> | algorithm}
Description This command will display the current link aggregation configuration of the
Switch.
Parameters
<value 1-4> − Specifies the group ID. The Switch allows up to 4 link
aggregation groups to be configured. The group number identifies each of
the groups.
algorithm − Allows you to specify the display of link aggregation by the
algorithm in use by that group.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
97
To Next Page
Loading...
