DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
200
Parameter Description
ECMP Advance Control
Mode Setting
Select the ECMP advance control mode settings here. This specifies the
number of ECMP or multipath routes and the number of next-hops of each
ECMP or multipath route that will be changed according to the specified value.
Options to choose from are 64, 128, 256, and 512.
Click the Apply button to accept the changes made.
RIP
RIP Settings
This window is used to display and configure Routing Information Protocol (RIP) settings.
To view the following window, click L3 Features > RIP > RIP Settings, as shown below:
Figure 6-177 RIP Settings Window
The fields that can be configured in RIP Global Settings are described below:
Parameter Description
RIP State Select to globally enable or disable the Routing Information Protocol (RIP)
feature here.
Click the Apply button to accept the changes made.
The fields that can be configured in Redistribution Configuration are described below:
Parameter Description
Redistribution
• First, select to enable or disable the RIP redistribution feature here.
• Second, select the routing protocol (domain) that will be redistributed into
RIP. Options to choose from are Connected, OSPF and Static. The
Static option means redistribute IP static routes. The Connected option
To Next Page
Loading...
