DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
235
The fields that can be configured are described below:
Parameter Description
PIM State Select this option to enable or disable the PIM protocol state. The default state
is disabled.
Mode Select the mode of PIM. The only supported mode is Sparse Mode.
PIM Passive
Select to enable or disable the Subscriber Source IP Check feature here. The
only supported state is disabled.
Hello Interval Enter the interval at which the router sends PIM hello messages periodically.
The range is from 1 to 18724. The default value is 30.
DR Priority
Enter the DR priority. The range is from 0 to 4294967295. The default value is
1.
Join Prune Interval Enter the join prune interval. The range is from 1 to 18000. The default value is
60.
BSR Domain Border Select to enable or disable the BSR Domain Border feature here. The default
state is enabled.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
PIM BSR Candidate page
This window is used to display and configure the PIM BSR candidate settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM BSR
Candidate, as shown below:
Figure 6-78 PIM BSR Candidate Window
The fields that can be configured are described below:
Parameter Description
Interface Name Specify the interface name.
Hash Mask Length
Enter the hash mask length for RP selection. The range is from 0 to 32. The
default value is 30.
Priority Enter the priority for a BSR candidate. The range is from 0 to 255. The default
value is 64.
Interval Enter the interval between originating Bootstrap message. The range is from 1 to
255. The default value is 60.
Click the Add button to add the PIM BSR candidate.
Click the Delete button to remove the specified entry.
To Next Page
Loading...
