D-Link DHP-541 - Page 15

15D-Link DHP-541 User Manual
Section 3 - Conguration
Plug the DHP-540 power cord into an electric outlet. Plug the
other end of the power cord to the back of the device and
then turn on the device by pushing the power switch to the
ON position located on the back of the device. Power source is
conrmed when the Power LED is illuminated.
Click Next to continue.
1. Connect the Ethernet cable from the LAN port to your
computer’s Ethernet Port.
2. Please ensure that the LED in front of the device is on.
Click Next to continue.