DIR-320 Wireless N150 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Configuring via Web-based Interface
To create
14
a new filtering rule for a device, click the Add button in the Rules section. In the line
displayed, you can specify the following parameters:
Parameter Description
MAC addresses
The MAC address of a device from the router's LAN. You can enter
the MAC address of a device connected to the router's LAN at the
moment. To do this, select the relevant device from the Known
IP/MAC addresses drop-down list (the field will be filled in
automatically).
IP address
The IP address of a device from the router's LAN. You can enter the
IP address of a device connected to the router's LAN at the moment.
To do this, select the relevant device from the Known IP/MAC
addresses drop-down list (the field will be filled in
automatically).
Set the name
Enter a name for the rule for easier identification. You can specify
any name.
Mode
Select an operating mode of the Yandex.DNS service for this rule.
Child: when this value is selected, the service blocks access to
malicious and fraudulent web sites and blocks access to adult
content.
Safe: when this value is selected, the service blocks access to
malicious and fraudulent web sites.
Protection off: when this value is selected, the service provides
the DNS server with no restrictions on access to unsafe web sites.
After specifying the needed parameters, click the Apply button.
To edit a rule for filtering, select a needed field in the relevant line of the table, change its value,
and click the Apply button.
To remove a rule for filtering, select the checkbox located to the left of the relevant rule and click
the Apply button.
To disable the Yandex.DNS service, deselect the Enabled checkbox on the Yandex.DNS /
Internet protection settings / Settings page.
14 When a new rule for filtering is created, a MAC address and IP address pair is displayed on the Net / LAN page.
The created pair will be deleted with the relevant rule.
Page 199 of 220
To Next Page
Loading...
