D-Link DIR-456U

34D-Link DIR-456U User Manual
Section 3 - Configuration
Routing
The Routing page allows you to specify custom routes that determine how data is moved around your network.
RIP SETTING
Select this box to enable routing.
Protocol in which the IP address is
routed through the internet.
Enhanced version of RIPv1
with added features such as
Authentication, Routing Domain,
Next Hop Forwarding, and Subnet-
mask Exchange.
RIP:
Ripv1:
RIPv2:
ROUTING RULES
Identies the rule.
Enter in the IP of the specied
network that you want to access
using the static route.
Enter in the subnet mask to be
used for the specied net work.
Enter in the gateway IP address to the specied network.
Enter in the amount of hops it will take to reach the specied network. Note: In a transmission path, each link is
terminated at a network device such as a router or gateway. The number of hops equals the number of routers
or gateways that data must pass through before reaching the destination.
Select this box to enable the rule.
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable: