D-Link dir-600m - DHCP Server Settings

19D-Link DIR-600M User Manual
Section 3 - Conguration
DHCP stands for Dynamic Host Control Protocol. The DIR-600M has a built-in DHCP server. The DHCP Server will automatically
assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting
their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers on, they will automatically load
the proper TCP/IP settings provided by the DIR-600M. The DHCP Server will automatically allocate an unused IP address from
the IP address pool to the requesting computer. You must specify the starting and ending address of the IP address pool.
Choose the DHCP Server option in the pulldown menu to
enable the DHCP server on your router. Choose None to disable
this function.
Enter the starting and ending IP addresses for the DHCP server’s
IP assignment.
Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may have an IP conict.
The maximum length of time for the IP address lease. Enter the Lease time in minutes.
Enter the domain name.
Enter the IP address of the rst DNS Server.
Enter the IP address of the second DNS Server, if there is one.
Enter the IP address of the third DNS Server, if there is one.
DHCP Mode:
IP Pool Range:
Max Lease Time:
Domain Name:
DNS Server 1:
DNS Server 2:
DNS Server 3:
Local Network
DHCP Server Settings
When you have nished conguring the new DHCP Server Settings, click the Apply Changes button.