D-Link dir-600m - Port Triggering

31D-Link DIR-600M User Manual
Section 3 - Conguration
This page allows you to enable port triggering to specify inbound trac to be sent to specic ports while other ports are in
use for outbound trac.
Port Triggering
Enable or disable the Nat Port Trigger.NAT Port Trigger:
Click the Apply Changes button to save any changes made.
Select an application from the pulldown list.
Enter the name of an application.
Enter a start match port.
Enter a end match port.
Select a protocol from the pulldown menu.
Enter a start relate port.
Enter an end relate port.
Select a protocol from the pulldown menu.
Select whether it will be outgoing or incoming.
Usual Application
Name:
User-dened
Application Name:
Start Match Port:
End Match Port:
Trigger Protocol:
Start Relate Port:
End Relate Port:
Open Protocol:
Nat Type:
Click the Apply Changes button to save any changes made.
The application will then be added to the Current Portrigger Table. Click the Delete button in the Action eld for an application
type if you wish to delete it.