DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Gateway IP address
Available if the Access point, Repeater, or Client mode was
selected the Initial Configuration Wizard.
The gateway IPv4 address which is used by the router to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Hostname The name of the device assigned to its IP address in the local subnet.
Figure 89. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Parameter Description
Dynamic IP Addresses
Mode of dynamic IP
address assignment
An operating mode of the router's DHCP server.
• Disable: The router's DHCP server is disabled, clients' IP
addresses are assigned manually.
• DHCP server: The router assigns IP addresses to clients
automatically in accordance with the specified parameters.
When this value is selected, the Start IP, End IP, Lease
time fields and the DNS relay switch are displayed on the
tab. Also when this value is selected, the DHCP Options
and Static IP Addresses sections are displayed on the tab.
• DHCP relay: An external DHCP server is used to assign IP
addresses to clients. When this value is selected, the
External DHCP server IP and Option 82 Remote ID
fields are displayed on the tab. Available if the Router,
WISP Repeater, or 3G/LTE modem mode was selected
in the Initial Configuration Wizard.
Page 110 of 236
To Next Page
Loading...
