DIR-815 AC1200 Wave 2 MU-MIMO Wi-Fi
Router with 3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
NAT
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
Firewall
If the switch is moved to the right, protection against external
connections for the LAN devices is enabled (for example, against
attempts to get information about the LAN devices or to hack a
device from the LAN). For security reasons, it is recommended not
to disable this function.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
RIP Move the switch to the right to allow using RIP for this connection.
Isolate connection
If the switch is moved to the right, the router uses an alternate
routing table for this connection. Enable this function only when
your ISP requires this.
Figure 84. The page for creating a new 3G connection. The USB Modem section.
Parameter Description
USB Modem
Mode
The value of the field specifies the type of the network to which the
router connects. Leave the Auto value to let the router connect
automatically to an available type of network, or select a needed
value from the drop-down list.
APN An access point name.
Dial number
A number dialed to connect to the authorization server of the
operator.
Page 106 of 240
To Next Page
Loading...
