DIR-815 AC1200 Wave 2 MU-MIMO Wi-Fi
Router with 3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
Creating LTE WAN Connection
If the PIN code check is enabled for the SIM card inserted into your USB modem, then prior to
creating an LTE WAN connection, go to the USB Modem menu and enter the PIN code
11
on the
page displayed (see the USB Modem section, page 168). Then on the connection creation page, in
the General Settings section, select the relevant value from the Connection type drop-down
list and specify the needed values.
Figure 86. The page for creating a new LTE connection. The General Settings section.
Parameter Description
General Settings
Interface
A physical or virtual WAN interface to which the new connection
will be assigned.
Connection name
A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
NAT
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
11 For some models of LTE USB modems it is required to disable the PIN code check on the SIM card prior to
connecting the USB modem to the router.
Page 109 of 240
To Next Page
Loading...
