D-Link DIR-820 - Page 118

DIR-820 AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
To activate the WPS function via the web-based interface, on the tab of the relevant band, click the
ENABLE WPS button.
When the WPS function is enabled, the Information section is available on the page.
Parameter Description
WPS state
The state of the WPS function:
• Configured (all needed settings are specified; these settings
will be used upon establishing the wireless connection)
• Unconfigured (after activating the WPS function, the SSID
and the encryption key will be configured automatically, the
network authentication type will be changed to WPA2-PSK).
Default PIN code
The PIN code of the router. This parameter is used when connecting
the router to a registrar to set the parameters of the WPS function.
Network name (SSID)
The name of the router's wireless network.
Network authentication The network authentication type specified for the wireless network.
Encryption
The encryption type specified for the wireless network.
Password PSK The encryption password specified for the wireless network.
UPDATE
Click the button to update the data on the page.
Page 118 of 210