DIR-820 AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
Telnet/SSH
On the System / Telnet/SSH page, you can enable or disable access to the device settings via
TELNET and/or SSH from your LAN. By default, access is disabled.
Figure 149. The System / Telnet/SSH page.
To enable access via TELNET and/or SSH, move the Enable Telnet switch and/or Enable SSH
switch to the right. In the Port field, enter the number of the router's port through which access will
be allowed (by default, the port 23 is specified for Telnet and the port 22 is specified for SSH).
Then click the APPLY button.
To disable access via TELNET and/or SSH again, move the Enable Telnet switch and/or Enable
SSH switch to the left and click the APPLY button.
Page 199 of 210
To Next Page
Loading...
