DIR-820 AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
SNMP
On the Advanced / SNMP page, you can enable and configure the SNMP agent of the router.
The SNMP agent is a service which sends data on the state and settings of the device where is it
enabled to the SNMP manager (the network management system of your ISP or system
administrator).
Figure 112. The Advanced / SNMP page.
In order to enable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the right. Then specify the needed parameters.
Parameter Description
Configuration
Hostname
A name of the router for identification in the SNMP manager.
The contact information
for the administrator
Additional information used to contact the administrator of the
router.
System location
Additional information used to locate the router.
If needed, specify an IP address of the remote subnet for which access to the SNMP agent of the
router will be allowed. To do this, in the Remote subnets section, click the ADD button and
enter the address of the subnet in the line displayed.
To remove an IP address of the subnet, click the Delete icon ( ) in the relevant line.
Page 141 of 210
To Next Page
Loading...
