DIR-820 AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
If the SNMP manager operates over SNMPv2c, create a read-only community which will be used
by the SNMP manager to get data on the device. To do this, in the Communities section, click the
ADD button and specify the community name in the line displayed.
To remove a community, click the Delete icon ( ) in the relevant line.
If the SNMP manager operates over SNMPv3, create a read-only user which will be used by the
SNMP manager to get data on the device. To do this, in the Users section, click
the ADD button ( ).
Figure 113. The window for adding a user.
In the opened window, specify the needed parameters:
Parameter Description
Name
Specify a username for access from the SNMP manager.
Authentication protocol
Select a required authentication method from the drop-down list or
leave the None value if authentication is not required.
Authentication
password
Specify a password for user authentication from the SNMP manager.
The field is displayed if the MD5 or SHA value is selected from the
Authentication protocol drop-down list.
Encryption protocol
Select a required encryption method from the drop-down list or
leave the None value if encryption is not required. The list is
displayed if the MD5 or SHA value is selected from the
Authentication protocol drop-down list.
Page 142 of 210
To Next Page
Loading...
