DIR-820 AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
In order to connect your device to a wireless ISP (WISP), on the Device mode page, from the
Connection method list, select the Wi-Fi value. Then from the Work mode list select the
WISP Repeater value. In this mode you can connect your device to another access point,
configure a WAN connection, set your own settings for the wireless network in the 2.4GHz and
5GHz bands, and set your own password for access to the web-based interface of the device.
Figure 34. Selecting an operation mode. The WISP Repeater mode.
Page 43 of 210
To Next Page
Loading...
