LED Status Description
Steady green The account is active.
Fast blinking red There is an incoming call to the account.
Slow blinking red The call is on hold.
Slow blinking red Registration is unsuccessful.
Off The line is not unapplied or idle.
Table 4 Programmable key LEDs for MWI
LED Status Description
Blinking red There are new voice mails.
Off There is no new voice mail.
2. Initial Connecting and Settings
2.1 Connect the phone
2.1.1 Connect to network
Step 1: Connect the IP Phone to the corporate IP telephony network. Before you connect the
phone to the network, please check if your network can work normally. You can do this in
one of two ways, depending on how your workspace is set up. Direct network
connection—by this method, you need at least one available Ethernet port in your
workspace. Use the Ethernet cable in the package to connect WAN port on the back of your
phone to the Ethernet port in your workspace. Since this VoIP Phone has router functionality,
whether you have a broadband router or not, you can make direct network connect. The
following two figures are for your reference.
Shared network connection—Use this method if you have a single Ethernet port in your
To Next Page
Loading...
