29D-Link DSL-2885A User Manual
For Dynamic IP (DHCP) refer to Dynamic IP (DCHP) on page 30.
For Static IP refer to Static IP on page 31.
For PPPoE refer to PPPoE on page 32.
For PPPoA refer to PPPoA on page 33.
For PPTP refer to PPTP on page 34.
For L2TP refer to L2TP on page 36.
Select whether the device should act as an xDSL Router or a
Residential Gateway.
Use the default setting unless otherwise instructed by your ISP.
If you selected Residential Gateway, sselect the Ethernet port that
will connect to the WAN. Use this setting if you do not intend to use
the built-in DSL modem.
Enable or disable tagged VLAN.
Enter the VLAN ID.
Enter the VLAN Priority from the default 0 (lowest) to 7 (highest).
Choose your Internet connection type from the drop-down menu.
You will be presented with the appropriate options for your
connection type.
WAN Access
T
ype:
PVC:
Ether WAN Port:
Enable Tagged
Vlan:
VLAN ID:
VLAN Priority:
My Internet
Connection Is:
In the Settings menu on the bar on the top of the page, click In
ternet to see the
Click Advanced Settings... to expand the list and
see all of the options.
To Next Page
Loading...
Need help?
General
