19
Installing the Drivers (continued)
Linux 2.6.9
This driver is designed for Kernel 2.6.x to 2.6.13. To compile the provided Linux driver, you
need the Linux 2.6 Kernel source. Also, please make sure the kernel is built with “Support
for Host-side, EHCI, OHCI, and UHCI” option.
1. Insert the driver CD-ROM into the CD-ROM drive of your computer and go to the
Drivers\Linux\ directory.
2. Copy the LINUX2.6.9_REV111 folder to your temporary directory.
3. Go to the
LINUX2.6.9_REV111 folder and execute the following command to
compile the driver.
[root@localhost linux2.6.9_rev111]# make
4. If compiling without errors, usbnet.ko will be created under the current directory.
5. If you want to use modprobe command to mount the driver, execute the following command
to install the driver on your Linux.
[root@localhost linux2.6.9_rev111]# make install
To mount the driver , go to the LINUX2.6.9_REV111 directory and execute the following
command:
[root@localhost linux2.6.9_rev111]# insmod usbnet
or
[root@localhost anywhere]# modprobe usbnet
To unmount the driver, just type the following command:
[root@localhost anywhere]# rmmod usbnet
To Next Page
Loading...
