14
Network Type:
Infrastructure is the factory default setting. Ad-Hoc mode is used for peer to
peer networking. See the Getting Started section in this manual for examples
of these network types.
Configuration
Using the Configuration Utility
SSID:
The Service Set Identifier is the name assigned to the wireless network.
The factory SSID setting is set to default. Make changes here to match the
SSID on existing Wireless Router or Access Point.
Tx Rate:
You can adjust the transmission rate to get the best signal possible depending
on your usage and your environment.
WEP Setting:
Will allow you to configure the Encryption for your DWL-120. By default
WEP is disabled.
Default Setting:
Reverts the DWL-120 back to its factory default settings
Advanced Setting:
To configure advanced settings for Power, RTS and Fragmentation Threshold.
To Next Page
Loading...
