About This Document
D-Link Unified Wired and Wireless Access System
November 7, 2011 Page 7
D-Link UAP CLI Command Reference
About This Document
In addition to the Web-based user interface, the D-Link Access Point DWL-x600AP includes a command-line
interface (CLI) for administering the access point. The CLI lets you view and modify status and configuration
information. This reference manual documents the commands and describes how to access and use the
interface.
Audience
This document is intended for the following audiences:
• System administrators who are responsible for configuring and operating the DWL-x600AP.
• Software engineers who integrate DWS-4000 software into their hardware platform can also benefit from
a description of the configuration options.
• Level 1 and/or Level 2 support providers.
This document assumes that the reader has an understanding of the DWS-4000 software base and has read
the appropriate specification for the relevant networking device platform. It also assumes that the reader has
a basic knowledge of Ethernet and networking concepts.
Refer to the release notes for the DWS-4000 application-level code. The release notes detail the platform-
specific functionality of the Switching, Routing, SNMP, Configuration, Management, and other packages. The
suite of features the DWS-4000 packages support is not available on all the platforms to which DWS-4000
software has been ported.
Acronyms and Abbreviations
In most cases, acronyms and abbreviations are defined on first use.
Note: This document contains both standalone and stacking commands. The stacking commands are
available on the DWS-4000 Series Unified Switch.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
